Showing posts with label microphone. Show all posts
Showing posts with label microphone. Show all posts

Monday, October 27, 2014

Lm318 Microphone preamplifier with tone control Diagram Circuit

This electronic project is a simple microphone preamplifier based on the LM318 op amp . The LM318 op amp is operated as a standard non-inverting amplifier. Resistor R1 provides an input path to ground for the bias current of the non-inverting input. The combination of R2 and C2 provides a frequency roll-off below 30 Hz. At 30 Hz and above the gain is relatively flat at about 50 dB, set by the ratio R3/R2. R3 furnishes negative feedback from the output to the inverting input of the op amp. C3 ac couples the preamp to the tone control section.
The top half of the tone control section is the bass control. The bottom half controls the treble frequency response. These tone controls (R5 and R8) require audio taper (logarithmic) potentiometers. The 50 k ohm potentiometer on the output can be used to set the output or gain of the preamp .

The circuit is very simple and require few electronic parts . This microphone preamplifier electronic project must be powered from a dual 15 volt DC power supply .
If you don’t want to use tone control function for the microphone preamplifier you can eliminate the tone control part from the project .
Read More..

Thursday, August 14, 2014

Speaker to microphone converter circuit


This schema is a simple approach for converting a loud speaker into a microphone. When the sound waves fall on the diaphragm of a speaker, there will be fluctuations in the coil and there will be a small proportional induced voltage. Usually this induced voltage is very low in magnitude and useless. Here in the schema the low voltage is amplified using transistors to produce a reasonable output. The transistor Q1 is wired in common base mode and produces the required voltage gain. The transistor Q2 is wired as an emitter follower to produce enough current gain. The voice quality of this schema will not be as much as a conventional microphone but quite reasonable quality can be obtained. To set up the schema, keep the preset R2 at around 10 Ohms and connect the battery. Now adjust R2 to obtain the optimum sound quality.







Notes.

* Assemble the schema on a general purpose PCB.
* Power the schema from a 9 V PP3 battery. * A 3 inch speaker can be used as K1. * All capacitors must be rated at least 15V. * An 8 Ohm speaker or head phone can be connected at the output to hear the picked sound.

Read More..